TENNESSEE EQUIPMENT MODERATED NEWSGROUP AND LIST > East Cost
> Massachusetts
> Auctions
> Clamp on forks style bucket bracket clamp-on loader
Clamp on forks style bucket bracket clamp-on loader
1000 POUND CAPACITY FRONT END LOADER BUCKET CLAMP
Examples of uses for one, or a set, of these clamps includes:
* Clamp on plow kit (two clamps + piece of tubing welded in between + 2 plow mounting flanges welded to the bottom of either clamp)
The possibilities are endless.
Each of these clamps are made completely out of heavy-duty steel, are fully DC- hand TIG and stick welded, and weight in at 26 pounds. The lower tube is .250†wall, 2†x 3†tubing and extends under the bucket by 12". The vertical tube is .188†wall, 3†by 3†square, the channel on the top is .375†thick, 3†wide, 2†tall channel, and the clamping disks are 3" wide and of .375†thick, CNC laser cut plate, welded around the threaded rod and under the bottom, with the bottom weld being ground to ensure a tight, flush fit. The capping plates are .25†thick and welded on all sided. The handles are 10" long, made from .75†cold roll steel with a chamfer machined into each end to center the stop washers before welding. The handle bushings are machined and allow the handle to slide freely. The threaded rod and nut are a 1â€-5 TPI Acme thread. This is a large, open thread that is very forgiving when contaminants get on it. This clamp is sold unpainted, so you can weld your desired attachments right to it.
This clamp is a very well made unit and will give many years of trouble free use. Once again, please click on the small pictures above to see the weld quality of the clamp before paint.
