TENNESSEE EQUIPMENT MODERATED NEWSGROUP AND LIST > East Cost
> Massachusetts
> Auctions
> Magnetic field probe hameg spectrum analyzer
Magnetic field probe hameg spectrum analyzer
GR: PRBEFPSPCTRMANAB PRBHIPSPCTRMANAB PRBMFPSPCTRMANAB
Picture 1 Magnetic Field Probe for SPECTRUM ANALYZER
Offered here is ONE (1 piece) of New excellent quality Magnetic Field Probe for HAMEG SPECTRUM ANALYZER - FREQUENCY SCANNER. Compatible with HZ530
This magnetic field probe gives a voltage result, its size is situate with the RF field strength. With this probe, it can distinguish the RF source of each circuit. The reason is that the interference sources are all low impedance (relatively small voltage change directly causes large current change). The transmitted interference source will directly produce RF magnetic field. The magnetic field transits from near place to far place, and the transition relation is that the value of H field is inversely proportional to the cube of the distance to the source. The distance to the source increases one time, H field will reduce to 1/8.
The magnetic field probe can help determine the position of interference source upon the quick increase of voltage of probe. Even if it is a circuit board, it can also find the interference source easily. It can tell which IC produces interference, which one does not. It can test in which frequency there is the largest amplitude. Thus it can find which element that does not to meet the purpose of EMC at an early stage. In addition, it can easily carry out disproof measurement and then make judgment. It can research the discharge area attached to cable or wire conduct interference, and research the shield effect.
If you combine the above Magnetic Field Probe with the following which we sell separately (click on the icon),
the combination forms an ideal toolkit for the investigation of RF electromagnetic fields. They are indispensable for EMI pre-compliance testing during product development, prior to third party testing. All our 3 hand-held probes comes with a built-in pre-amplifier covering the frequency range from 100 kHz to over 1000 MHz. The probes - one magnetic field probe, one electric field probe, and one high impedance probe - are all matched to the 50W inputs of spectrum analyzers or RF-receivers. The power can be supplied either from batteries, Ni-Cads or through a power cord directly connected to a HAMEG HM5005 (HM-5005)/HM5006 (HM-5006)/HM5010 (HM-5010)/HM5011 (HM-5011)/HM5012 (HM-5012)/HM5014 (HM-5014) series spectrum analyzer.
Signal feed is via a 1.5m BNC-cable. When used in conjunction with a spectrum analyzer or a measuring receiver, the probes can be used to locate and qualify EMI sources, as well as evaluate EMC problems at the breadboard and prototype level. They enable the user to evaluate radiated fields and perform shield effectiveness comparisons. Mechanical screening performance and immunity tests on cables and components are easily performed.
REFUND POLICY / REPLACEMENT POLICY / RETURN POLICY:
http://eb.kawagebo.net/Industrial/SMD/SpctrmAn/AZ530M_MagFldProbe_SO_A1a.jpg
